Citation Impact
Citing Papers
Metal additive manufacturing in aerospace: A review
2021 Standout
Towards sustainable concrete
2017 Standout
Minimization of surface roughness and residual stress in abrasive water jet cutting of titanium alloy Ti6Al4V
2023
Heteroepitaxial recrystallization: A new mechanism discovered in a polycrystalline γ-γ′ nickel based superalloy
2016
Magnolol-based bio-epoxy resin with acceptable glass transition temperature, processability and flame retardancy
2020 Standout
Powder-bed additive manufacturing for aerospace application: Techniques, metallic and metal/ceramic composite materials and trends
2019
New Insights into Perfluorinated Sulfonic-Acid Ionomers
2017 Standout
A Novel Approach to Structure Modification of Brasses by Combination of Non-equilibrium Heat Treatment and Friction Stir Processing
2019
Hot deformation characteristics and dynamic recrystallization of the MoNbHfZrTi refractory high-entropy alloy
2015
Biorenewable Epoxy Resins Derived from Plant-Based Phenolic Acids
2016
Evolving neural network using real coded genetic algorithm for permeability estimation of the reservoir
2011
Dynamic and post-dynamic recrystallization under hot, cold and severe plastic deformation conditions
2013 Standout
A short-term load forecasting model of natural gas based on optimized genetic algorithm and improved BP neural network
2014 Standout
Mechanical properties of Nafion 212 proton exchange membrane subjected to hygrothermal aging
2013
Microstructure and Mechanical Properties of Austenitic Stainless Steels after Dynamic and Post‐Dynamic Recrystallization Treatment
2018
Artificial intelligence, machine learning and deep learning in advanced robotics, a review
2023 Standout
Deterioration of the fire structural resistance of sandwich composite under tension due to water absorption
2016
A review of dynamic recrystallization phenomena in metallic materials
2016 Standout
Current state of Fe-Mn-Al-C low density steels
2017 Standout
A critical review of experimental results and constitutive descriptions for metals and alloys in hot working
2010
Cemented paste backfill for mineral tailings management: Review and future perspectives
2019 Standout
Cements in the 21 st century: Challenges, perspectives, and opportunities
2017
Hot deformation characterization of duplex low-density steel through 3D processing map development
2015
Development and exploration of refractory high entropy alloys—A review
2018 Standout
Constitutive modelling of cemented paste backfill: A data-mining approach
2018
Dynamic recrystallisation model in precipitation-hardened superalloys as a tool for the joint design of alloys and forming processes
2016
Hybrid additive manufacturing of Inconel 718 for future space applications
2020
Friction stir welding/processing of metals and alloys: A comprehensive review on microstructural evolution
2020 Standout
Review of current trends in research and applications of sandwich structures
2018 Standout
Recent advances in ageing of 7xxx series aluminum alloys: A physical metallurgy perspective
2018
Microstructure evolution and mechanical properties of Mg–Nd–Y alloy in different friction stir processing conditions
2015
Simulation of Austenite Flow Curves under Industrial Rolling Conditions Using a Physical Dynamic Recrystallization Model
2012
Microstructure evolution and mechanical properties of friction stir welding super-austenitic stainless steel S32654
2017
Works of Y.C. Lin being referenced
Effects of strain on the workability of a high strength low alloy steel in hot compression
2009
Electrochemical corrosion behaviors of a stress-aged Al–Zn–Mg–Cu alloy
2016
Prediction of static recrystallization in a multi-pass hot deformed low-alloy steel using artificial neural network
2008
Dynamic recrystallization behavior of a typical nickel-based superalloy during hot deformation
2014
Investigation of the effect of hygrothermal conditions on epoxy system by fractography and computer simulation
2005
Constitutive modeling for elevated temperature flow behavior of 42CrMo steel
2007
A combined Johnson–Cook and Zerilli–Armstrong model for hot compressed typical high-strength alloy steel
2010
Precipitation hardening of 2024-T3 aluminum alloy during creep aging
2012
Effects of two-stage creep-aging on precipitates of an Al–Cu–Mg alloy
2014
Evolution of precipitates during two-stage stress-aging of an Al-Zn-Mg-Cu alloy
2016
Investigation of uniaxial low-cycle fatigue failure behavior of hot-rolled AZ91 magnesium alloy
2012
EBSD study of a hot deformed nickel-based superalloy
2015
Constitutive models for high-temperature flow behaviors of a Ni-based superalloy
2014
EBSD analysis of evolution of dynamic recrystallization grains and δ phase in a nickel-based superalloy during hot compressive deformation
2016
A new dynamic recrystallization kinetics model for a Nb containing Ni-Fe-Cr-base superalloy considering influences of initial δ phase
2017
Study of static recrystallization kinetics in a low alloy steel
2008
Investigation of moisture diffusion in epoxy system: Experiments and molecular dynamics simulations
2005
Effects of hygrothermal aging on anisotropic conductive adhesive joints: experiments and theoretical analysis
2006
Study of metadynamic recrystallization behaviors in a low alloy steel
2008
Application of neural networks to predict the elevated temperature flow behavior of a low alloy steel
2008
A new mathematical model for predicting flow stress of typical high-strength alloy steel at elevated high temperature
2009
Hot deformation behavior and processing map of a typical Ni-based superalloy
2013
Precipitation in Al–Cu–Mg alloy during creep exposure
2012
New constitutive model for high-temperature deformation behavior of inconel 718 superalloy
2015
Moisture sorption–desorption–resorption characteristics and its effect on the mechanical behavior of the epoxy system
2005
A modified Johnson–Cook model for tensile behaviors of typical high-strength alloy steel
2010
Study of static recrystallization behavior in hot deformed Ni-based superalloy using cellular automaton model
2016
Effect of creep-aging on precipitates of 7075 aluminum alloy
2013
Microstructural evolution and constitutive models to predict hot deformation behaviors of a nickel-based superalloy
2016
Study of dynamic recrystallization in a Ni-based superalloy by experiments and cellular automaton model
2015
The kinetics of dynamic recrystallization of 42CrMo steel
2012
Study of microstructural evolution during static recrystallization in a low alloy steel
2008
Prediction of 42CrMo steel flow stress at high temperature and strain rate
2007
EBSD study of grain growth behavior and annealing twin evolution after full recrystallization in a nickel-based superalloy
2017
Kinetics equations and microstructural evolution during metadynamic recrystallization in a nickel-based superalloy with δ phase
2016