Citation Impact
Citing Papers
Building Materials in the Operational Phase
2013
Climate adaptive building shells: State-of-the-art and future challenges
2013 Standout
Phase change materials and thermal energy storage for buildings
2015 Standout
An experimental investigation on morphological, mechanical and thermal properties of date palm particles reinforced polyurethane composites as new ecological insulating materials in building
2017
Agricultural waste management strategies for environmental sustainability
2021 Standout
Design and Implementation of Smart Home Control Systems Based on Wireless Sensor Networks and Power Line Communications
2014 Standout
Viability of exterior shading devices for high-rise residential buildings: Case study for cooling energy saving and economic feasibility analysis
2014
Energy saving in lighting system with fuzzy logic controller which uses light-pipe and dimmable ballast
2013
Daylighting metrics based on illuminance, distribution, glare and directivity
2011
Occupant behavior modeling for building performance simulation: Current state and future challenges
2015 Standout
Emerging Engineered Wood for Building Applications
2022 Standout
Effect of LED lighting on the cooling and heating loads in office buildings
2013 Standout
Research on tunnel ventilation systems: Dust Diffusion and Pollution Behaviour by air curtains based on CFD technology and field measurement
2018 Standout
Optimization of the building integrated photovoltaic system in office buildings—Focus on the orientation, inclined angle and installed area
2011 Standout
Life cycle greenhouse gas emissions of hemp–lime wall constructions in the UK
2012
Thermal analysis of a ventilated facade with PCM for cooling applications
2013
Energy saving potential and strategies for electric lighting in future North European, low energy office buildings: A literature review
2011
Life cycle assessment (LCA) and life cycle energy analysis (LCEA) of buildings and the building sector: A review
2013 Standout
Reinforcement learning for building controls: The opportunities and challenges
2020 Standout
A review on simulation-based optimization methods applied to building performance analysis
2013 Standout
Passive cooling dissipation techniques for buildings and other structures: The state of the art
2012
Experimental performance investigation of natural, mechanical and hybrid ventilation in urban environment
2007
A review of solar thermal technologies☆
2009 Standout
Modeling energy efficiency of bioclimatic buildings
2005
Thermal simulation of buildings with double-skin façades
2005
Ventilation rates in European office buildings: A review
2013
Hygromorphic materials for sustainable responsive architecture
2015 Standout
Impacts of building geometry modeling methods on the simulation results of urban building energy models
2018 Standout
The gap between predicted and measured energy performance of buildings: A framework for investigation
2014 Standout
Lightswitch-2002: a model for manual and automated control of electric lighting and blinds
2004 Standout
A review of data-driven building energy consumption prediction studies
2017 Standout
Numerical simulations of the effect of outdoor pollutants on indoor air quality of buildings next to a street canyon
2015
Thermal insulation alternatives of historic brick buildings in Baltic Sea Region
2014 Standout
A comprehensive review of solar facades. Transparent and translucent solar facades
2012
Solar radiation calculation methodology for building exterior surfaces
2005
Perspectives of double skin façade systems in buildings and energy saving
2011
Simulation of façade and envelope design options for a new institutional building
2007
Climatic and internal factors affecting future UK office heating and cooling energy consumptions
2007
A comparison of the occupant comfort in a conventional high-rise office block and a contemporary environmentally-concerned building
2010
Energy analysis of the built environment—A review and outlook
2015
Mining building performance data for energy-efficient operation
2010
Review of relationship between indoor and outdoor particles: I/O ratio, infiltration factor and penetration factor
2010 Standout
Methodologies and Advancements in the Calibration of Building Energy Models
2015
Application of life-cycle assessment to early stage building design for reduced embodied environmental impacts
2012 Standout
A multi-stage optimization method for cost-optimal and nearly-zero-energy building solutions in line with the EPBD-recast 2010
2012
A methodology for design of environmentally optimal buildings by variable grouping
2004
Energy efficiency and thermal comfort in historic buildings: A review
2016 Standout
Dynamic Daylight Performance Metrics for Sustainable Building Design
2006
Lighting performance and electrical energy consumption of a virtual window prototype
2014
Building simulation as an assisting tool in decision making
2007
Quantifying the potential of automated dynamic solar shading in office buildings through integrated simulations of energy and daylight
2011 Standout
A review of the current work potential of a trombe wall
2020 Standout
Passive cooling in a low-energy office building
2005
Energy retrofit of historic buildings: Environmental assessment of cost-optimal solutions
2015
Bulk nanostructured thermoelectric materials: current research and future prospects
2009 Standout
Recent advances and applications of machine learning in solid-state materials science
2019 Standout
Using results from field surveys to predict the effect of open windows on thermal comfort and energy use in buildings
2007
A simplified framework to assess the feasibility of zero-energy at the neighbourhood/community scale
2014
Experimental study of small-scale solar wall integrating phase change material
2011
Comparison between simplified and detailed EnergyPlus models coupled with an urban canopy model
2017
Enhancing environmental sustainability over building life cycles through green BIM: A review
2015 Standout
The development of commercial wind towers for natural ventilation: A review
2011
Thermal inertia in buildings: A review of impacts across climate and building use
2017
Experimental study of the influence of thermal mass on thermal comfort and cooling energy demand in residential buildings
2020 Standout
Energy planning and forecasting approaches for supporting physical improvement strategies in the building sector: A review
2016
Review on building energy performance improvement using phase change materials
2017 Standout
Building Energy Management: Integrated Control of Active and Passive Heating, Cooling, Lighting, Shading, and Ventilation Systems
2012
Green building research–current status and future agenda: A review
2013 Standout
Cooling load reduction in office buildings of hot-arid climate, combining phase change materials and night purge ventilation
2015
Polyurethane Foams: Past, Present, and Future
2018 Standout
Satisfaction based Q-learning for integrated lighting and blind control
2016
Estimating the energy consumption and power demand of small power equipment in office buildings
2014 Standout
Designing-in performance: A framework for evolutionary energy performance feedback in early stage design
2013
A review on global solar energy policy
2011 Standout
Principles and criteria for assessing urban energy resilience: A literature review
2016 Standout
The contextual factors contributing to occupants' adaptive comfort behaviors in offices – A review and proposed modeling framework
2014
Strategies to improve the energy performance of multiple-skin facades
2006 Standout
Energy savings by energy management systems: A review
2015 Standout
Heat gain reduction by means of thermoelectric roof solar collector
2004
The Framework of an Optimization Model for Building Envelope
2013
Occupant productivity and office indoor environment quality: A review of the literature
2016 Standout
Sustainability in the construction industry: A review of recent developments based on LCA
2008 Standout
Comparison of theoretical and statistical models of air-conditioning-unit usage behaviour in a residential setting under Japanese climatic conditions
2009 Standout
An investigation of the impact of building orientation on energy consumption in a domestic building using emerging BIM (Building Information Modelling)
2016 Standout
Investigation of the performance of a ventilated wall
2011
A review of computational optimisation methods applied to sustainable building design
2013 Standout
Economic and environmental benefits of thermal insulation of building external walls
2011 Standout
A review on macro-encapsulated phase change material for building envelope applications
2018 Standout
A review on optimized control systems for building energy and comfort management of smart sustainable buildings
2014 Standout
Assessment of overheating risk and the impact of natural ventilation in educational buildings of Southern Europe under current and future climatic conditions
2018
A review on phase change material (PCM) for sustainable passive cooling in building envelopes
2016 Standout
Works of André De Herde being referenced
Wind pressure distribution influence on natural ventilation for different incidences and environment densities
2005
Environmental and economic performance of heating systems for energy-efficient dwellings: Case of passive and low-energy single-family houses
2011
"ARCHITECT FRIENDLY": A COMPARISON OF TEN DIFFERENT BUILDING PERFORMANCE SIMULATION TOOLS
2009
Simulation-based decision support tool for early stages of zero-energy building design
2012
Design of a new single-patch sky and sun simulator
2006
Is day natural ventilation still possible in office buildings with a double-skin façade?
2003
Guidelines for improving natural daytime ventilation in an office building with a double-skin facade
2006
Tool For Design Decision Making: Zero Energy Residential Buildings In Hot Humid Climate
2013
Natural ventilation in a double-skin facade
2003
Design of low energy office buildings
2003
Are energy consumptions decreased with the addition of a double-skin?
2006
Greenhouse effect in double-skin facade
2006
Impacts of occupant behaviours on residential heating consumption for detached houses in a temperate climate in the northern part of Europe
2012
Hygrothermal Performance of Lime-Hemp Wall Assemblies
2009
Designing the Malqaf for summer cooling in low-rise housing, an experimental study
2009
Optimal operation of a south double-skin facade
2003
Sensitivity analysis in building performance simulation for summer comfort assessment of apartments from the real estate market
2013
Impact of control rules on the efficiency of shading devices and free cooling for office buildings
2005
How to use natural ventilation to cool narrow office buildings
2004
The most efficient position of shading devices in a double-skin facade
2006
Achieving informed decision-making for net zero energy buildings design using building performance simulation tools
2013
The ‘Architect-friendliness’ Of Six Building Performance Simulation Tools: A Comparative Study
2011
Selection criteria for building performance simulation tools: contrasting architects' and engineers' needs
2011
Natural cooling strategies efficiency in an office building with a double-skin façade
2004
Global energy savings in offices buildings by the use of daylighting
2002